TDT - Productivity solutions for technical illustrators.

Step 16
Go to page 29, Symbol #061

Copy the “U” angle and go to page 31, Symbol #063 and paste. Paste again and apply a vertical mirror and move the ends up and down a bit. Weld together and then create a 5.00-inch rectangle.

Center the rectangle on the box and trim it from the box. Delete the rectangle and any extra nodes. Make sure all of the straight segments are straight lines.

Step 17
The next two are variations of the last two. Go to page 30, Symbol #062

Copy the “U” extrusion and go to page 32, Symbol #064 and paste. Create a rectangle 0.50 inches wide by 1.5 inches high. Snap it to the left side. Duplicate and snap it to the right side.

Weld together. Delete any extra nodes. Make sure all of the segments are straight lines.

Step 18
Go to page 31, Symbol #063

Copy the “U” angle and go to page 33, Symbol #065 and paste. Get a copy of the “L” angle and apply a vertical mirror and then modify as shown. Snap it to the right side. Duplicate, mirror horizontally and snap it to the left side.

Weld together. Delete any extra nodes. Make sure all of the straight segments are straight lines.