Isometric Symbol Fonts - Assembling the screws

TDT - Productivity solutions for technical illustrators.

Step 07
To create the cap heads use the process below:

This set requires smaller thread sets. Locate the 4.375-inch width thread set, duplicate, and move off to the side.

Duplicate the various head and align it to the top or bottom of the threads as shown.
Center each head on the threads.
Once everything is positioned marquee select sets of components and combine (Ctrl+L) them and then break apart (Ctrl+K) the result. Repeat the process until everything is broken apart.
Use the Shaping Docker to Trim the unneeded segments as shown. Be sure to delete any overlapping unneeded segments.
Re-combine (Ctrl+L) each thread and head set individually. Note: Only one set is shown for clarity. You must go through the entire process for each thread set and head combination. Creates 40 cap head machine screws.

Step 08
To create the pan heads use the process below:

This set requires smaller thread sets. Locate the 4.375-inch width thread set, duplicate, and move off to the side.

Duplicate the various head and align it to the top or bottom of the threads as shown.
Center each head on the threads.
Once everything is positioned marquee select sets of components and combine (Ctrl+L) them and then break apart (Ctrl+K) the result. Repeat the process until everything is broken apart.
Use the Shaping Docker to Trim the unneeded segments as shown. Be sure to delete any overlapping unneeded segments.
Re-combine (Ctrl+L) each thread and head set individually. Note: Only one set is shown for clarity. You must go through the entire process for each thread set and head combination. Creates 32 pan head machine screws.

	Start		Back	1	2	3	4	5		Next		End	Learn More