 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Isometric
Symbol Fonts - Assembling the parts -
page 5
|
 |
Step 11
Creating the wood screws.
Dupe and resize the threads of the wood screws according to the table
below:
- Hex
= 4.125 inches wide
- Round
= 4.50 inches wide
- Cap
= 4.125 inches wide
- Pan
= 4.375 inches wide
- Flat
= 4.146 inches wide
Then use the procedure outlined below for each head:
- Duplicate
the various heads and align it to the top or bottom of the threads as
shown.
- Center
each head on the threads.
- Once
everything is positioned marquee select sets of components and combine
(Ctrl+L) them and then break apart (Ctrl+K) the result. Repeat the
process until everything is broken apart.
- Use
the Shaping Docker to Trim the unneeded segments as shown. Be sure to
delete any overlapping unneeded segments.
- Re-combine
(Ctrl+L) each thread and head set individually. Note: Only one set is
shown for clarity. You must go through the entire process for each
thread set and head combination. Creates 92 screws.
|
|
 Step
12
Ok, everything is almost ready. The accompanying
illustration is to provide a little guidance about how organize all this
stuff. It should also be obvious that all of these symbols will not fit
in one symbol font (214 positions). Next month we will perform the final
organization and export of your fonts.
Purchase
our Tech Drawing Tools and work more efficiently
|
Home,
About, Contact,
FAQ, Shop,
Products, Services,
Learn, Tips
and Tricks, Tools
© 1997 - 2001
John M. Morris
