TDT - Productivity solutions for technical illustrators.

Take the three ellipses used for the neck and space them apart by 0.375 inches each. Render the center one with the darker linear fill.

Blend the bottom to the center then separate and ungroup.

Blend the top to the center then separate, ungroup and then group all of it together.

Align horizontally centered over the base.

Take the two ellipses used for the cap and space them apart by 1.00 inches. Duplicate the bottom one and move it up about 0.50 inches. Render the center one with a lighter linear fill. Render the top one with an even lighter linear fill.

Blend the bottom to the center then separate and ungroup.

Blend the top to the center then separate, ungroup and then group all of it together.

Align horizontally centered over the base.

Use the Extrusion tool to apply an extrusion to the Stem with the following settings: Back parallel, x = 0.00 y = -0.22. VP locked to object and vanishing point relative to object center. Separate, render as shown. Group the base together.

Align horizontally centered over the base.