 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||
|
|
|
||||||||||||
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||
|
|
|
||||||||||||
|
|
|
|
|
|
|
||||||||
| Drawing Isometric Piping - page 4 |
 |
Manually move, size, and position the elliptical hole over the end of your pipe until you achieve the proper result. |
 |
Engineering Drawing of a z-bend pipe Note: In this exercise you will draw directly in isometric. |
 |
Check your Preferences (Crtl+J) and make sure that the constrain angle is set to 15 degrees. Choose the straight line pencil tool. Draw straight line segment 1 while holding the constrain (Ctrl) key to 30 degrees. Connect segment 2 at - 30 degrees to about the proportions shown. Add segment 3 at -90 degrees. Segment 4 at -30 degrees and complete the primitive with segment 5 at 30 degrees. |
Home,
About, Contact,
FAQ, Shop,
Products, Services,
Learn, Tips
and Tricks, Tools
© 1997 - 2001 John M. Morris
