 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||
|
|
|
||||||||||||
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||
|
|
|
||||||||||||
|
|
|
|
|
|
|
||||||||
| Creating the Hardware - page 3 |
 |
Re center the two smaller ellipses using the arrange command. Use the property bar to move the inside ellipse up 0.50 inches. With the node edit tool modify the lower ellipse to simulate the taper effect. |
 |
Render as shown. Duplicate and weld the tapered section together and move down 0.50 + 0.25 inches. Send the taper to the back. |
 |
Rotate 120 degrees adjust the edge pad of the fill if necessary. Group (Ctrl+G) each of the wheel nuts together. |
Home,
About, Contact,
FAQ, Shop,
Products, Services,
Learn, Tips
and Tricks, Tools
© 1997 - 2001 John M. Morris
